Ā


Both mandrels are #2 MorseĀ taper, both have a 3/8″x16tpi thread and the step or collar that is the sameĀ diameter as the stoppers.Ā The differences are detailed below: #2MT-A Ā 3/8″ x 16 tpi screw with a “slit” in theĀ threadsĀ so it is self tapping (**see bottom picture on left).Ā The Morse taper end is threaded for a 1/4″ x 20 tpiĀ drawbar.Ā ** the section between the Morse taper and the section that is the same diameter asĀ the stoppers is 7/8″ diameter.Ā This can only be used in the Morse taper.
NOT FOR USE IN A CHUCK.











Reviews
There are no reviews yet.